Outside corner 90° for verge sheet flat roof / wooden wedge plank

Please note that colored sheet metal profiles are only color-coated on one side!

The leg length of the corner is 20cm.

The standard angle (c=70°) is suitable for common wooden cant strips 5cm high and 14cm wide.

Can be used on flat roofs and is suitable for roof waterproofing with bitumen or plastic membranes.

The sheet metal profile is installed on the finished roof waterproofing, meaning the wooden cant strip is first attached to the roof sheathing, then the roof waterproofing membrane is led up to the top edge of the wooden cant strip. Finally, the roof edge profile is installed; fastening can be done on the face side or roof side with plumbing screws (see also installation tips). The horizontal leg A is led OVER or rests on the roof covering. The sheets are laid with an 8-10cm overlap at the joints.

Material description:

Material surfaces:
The surfaces of mill-finish materials such as titanium zinc, natural aluminum, copper, and stainless steel may show scratches due to processing. These do not affect the quality, grade, or lifespan of the material. As a rule, these are no longer visible from a distance of 2-3m or partly disappear due to the formation of an oxide layer. For enhanced optical requirements or very short viewing distances (e.g., balcony railings, etc.), we recommend using surface-treated materials such as color-coated aluminum. This is delivered with a protective film, which must then be removed before installation.

Dimensional tolerances:
Due to tolerances in the raw material or manufacturing, the sheet metal profiles may show slight dimensional deviations. These are defined as follows:
- Length tolerance for 1.0 or 2.0m +/- 5mm
- Deviations in leg lengths +/- 2mm
- Deviations in bending angles +/- 3°

Material-specific information:
All articles listed below are so-called non-ferrous metals, which means these materials do not rust.

Color-coated aluminum:
Important note: The color coating is always applied only to one side; the back of the sheets is colorless! The sheets are delivered with a protective film (sometimes transparent). This must be removed before installation!

Surface:
- industrially applied polyester lacquer coating
- no staining, visually appealing, consistent surface
- permanently weather-resistant, no flaking
- slight color fading due to UV radiation